2013 Genesis OBDll will not connect to ECU

[packettec]

Torque app connects to adapter fine start polling green light will stop blinking like its connected then drop back to polling.
App setting confirms connection to adapter but not ECU. Adapter works fine on multiple other vehicles.

 

[Gunkk]

Did you try a different adapter? Not all are created equal. FWIW, this one works fine in my 2012.

https://www.amazon.com/Veepeak-Bluetooth-Diagnostic-Supports-DashCommand/dp/B011NSX27A

 

[packettec]

Did you try a different adapter? Not all are created equal. FWIW, this one works fine in my 2012.

https://www.amazon.com/Veepeak-Bluetooth-Diagnostic-Supports-DashCommand/dp/B011NSX27A

Yes, when I first noticed it wasn't connecting tried another Dongle that had previously worked. Backed off of it because I was working on putting the car back together from a collision. I have it back together and I have all kinds of wired problems ie no A/C,Tach,Temp gauge and not getting outside ambient temp this maybe why no A/C and of course not able to read ECU. At this point I may pull the front bumper back off and take a closer look at the wiring loom that runs across the front.