balance
Hasn't posted much yet...
Am planning on putting a Borla cat back system into my 2102 4.6.
Spoke to both Borla and my local distributor and I should have system within two weeks.
The only concern I have is the change in rear bumper on the 2012 (it now has a "built in" port rather than the oval exhaust on it's predecessors. Has anyone done an installation to date on a '12 and if so, would love to see pics (Magnaflow or Borla). Assuming my exhaust guy and I could jury up a connector to the final muffler and keep her very stealth exhaust port, but I admit to liking the Borla twins on each side, just not sure how they will look poking out of the four sided cutouts in the bumper.
Moving ahead regardless, but would love to know if anyone has gone here before.
Finally bumped up over 1,000 miles on the clock and am just amazed how this motor rocks when you run her up through the tach with the shiftronic.
Spoke to both Borla and my local distributor and I should have system within two weeks.
The only concern I have is the change in rear bumper on the 2012 (it now has a "built in" port rather than the oval exhaust on it's predecessors. Has anyone done an installation to date on a '12 and if so, would love to see pics (Magnaflow or Borla). Assuming my exhaust guy and I could jury up a connector to the final muffler and keep her very stealth exhaust port, but I admit to liking the Borla twins on each side, just not sure how they will look poking out of the four sided cutouts in the bumper.
Moving ahead regardless, but would love to know if anyone has gone here before.
Finally bumped up over 1,000 miles on the clock and am just amazed how this motor rocks when you run her up through the tach with the shiftronic.