Getting ready for a long road trip and I did not feel comfortable just having the donut. I ordered an aftermarket wheel and tire package from Tire Rack. I also ordered the TPMS sensor. I removed the donut and put the new wheel/tire in the vacated spot and screwed it back down. The OEM plastic holder for the jack, handle, etc is too big to reinstall so I put it aside. There was a gap of about an inch and a half between the top of the tire and the top of the area where the rug would go back. I cut a piece of plywood 29 inches long and about as wide as the tire. That still left about an inch gap between the top of the tire and the bottom of the plywood. I cut 2 one inch pieces of plywood, about 4 inches wide and slightly shorter than my original piece. When placed on the plywood they rest on top of the tire and give support to the piece of plywood and anything heavy you want to put in the trunk. I wrapped the tools in a towel and placed them in the hole in the tire, along with a small compressor. Replaced the trunk liner and job was done. Took about an hour not moving very quickly. Piece of mind!!