Still hyperflashing with V6 Triton LEDs and load resistor

[jime]

This just keeps getting worse. I experienced right turn signal hyperflashing with the SIRIUS LED and again with a warranty replacement. So I purchased the V6 Triton VLEDs with the optional load resistor kit. After installation the right turn signal is still hyperflashing. I tried switching the left VLED to the right side and am still experiencing hyperflashing.
Any suggestions???
Thanks, JimE

 

[Suburbazine]

Unplug the load resistor kit, it’s not needed nor for DRL use.

you may also need to try swapping the bulb socket between headlights and see if the problem follows, a burnt one causes issues too.

 

[jime]

Problem area identified. I started switching parts from right turn signal to left turn signal: LED, load resistor, circuit connectors and then the sockets. When I switched the sockets the hyperflashing switched from the right to the left side.
Lesson learned: If you have hyperflashing problem with LEDs, test the sockets before spending $130 on a different system.

 

[bufub]

Problem area identified. I started switching parts from right turn signal to left turn signal: LED, load resistor, circuit connectors and then the sockets. When I switched the sockets the hyperflashing switched from the right to the left side.
Lesson learned: If you have hyperflashing problem with LEDs, test the sockets before spending $130 on a different system.

FYI, TRITON has a new improved socket I think they'll provide to any valid owner. One of mine separated in the middle of the body and they sent it right away - better one piece design