ahrajani
Registered Member
- Joined
- Jun 14, 2021
- Messages
- 135
- Reaction score
- 105
- Points
- 43
- Location
- California
- Genesis Model Year
- 2023
- Genesis Model Type
- Genesis G80 EV
I have been looking for a way to control the excessive bounce/body roll on my 2021 G80 2.5T Prestige. Aftermarket chassis and suspension parts are scarce, however.
Rear Subframe Brace: The rear subframe brace set from Shark Racing has two braces, but only one of them fit the 2.5T. I drove with it for about 3 weeks. The impact was noticeable, but I would say modest. LINK.

Luxon Aluminum Strut Tower Bar: Next, I added a strut tower bar from Luxon. This was very easy to install and tighten. I drove with this for about a week. I noticed the steering wheel firmed up and the input to the wheels felt much more connected/direct. LINK.

Luxon Front and Rear Stabilizer Bar (Sway Bar / Anti-Roll Bar): Next, I added these front and rear stabilizers from Luxon. These bars were probably twice the weight of the original bars and much thicker as well. I’ve driven with them for about a week. The steering wheel firmed up more (which I prefer), body roll was reduced a significant amount. I can now take turns and change directions much faster and with more confidence. Overall the vehicle feels sure-footed and it lets the car hide its body weight in the corners. The ride is not noticeably harsher. LINK.

Note, I got an alignment immediately after installing these parts. Everything tracks well.
Overall impression: Combined, these have made a significant improvement in the ride and handling. However, TBH, there is still some unwanted “bounce” after you hit a bump. I don’t think that problem can be completely solved without a coilover setup that’s properly dialed in. I haven’t seen any coilovers released for this vehicle yet, but that will likely be my next project!
Rear Subframe Brace: The rear subframe brace set from Shark Racing has two braces, but only one of them fit the 2.5T. I drove with it for about 3 weeks. The impact was noticeable, but I would say modest. LINK.

Luxon Aluminum Strut Tower Bar: Next, I added a strut tower bar from Luxon. This was very easy to install and tighten. I drove with this for about a week. I noticed the steering wheel firmed up and the input to the wheels felt much more connected/direct. LINK.

Luxon Front and Rear Stabilizer Bar (Sway Bar / Anti-Roll Bar): Next, I added these front and rear stabilizers from Luxon. These bars were probably twice the weight of the original bars and much thicker as well. I’ve driven with them for about a week. The steering wheel firmed up more (which I prefer), body roll was reduced a significant amount. I can now take turns and change directions much faster and with more confidence. Overall the vehicle feels sure-footed and it lets the car hide its body weight in the corners. The ride is not noticeably harsher. LINK.

Note, I got an alignment immediately after installing these parts. Everything tracks well.
Overall impression: Combined, these have made a significant improvement in the ride and handling. However, TBH, there is still some unwanted “bounce” after you hit a bump. I don’t think that problem can be completely solved without a coilover setup that’s properly dialed in. I haven’t seen any coilovers released for this vehicle yet, but that will likely be my next project!

