Rey
Registered Member
I just installed a Sprint Booster. It transformed my Genesis 4.6. Throttle response is "right now." The transmission also downshifts at anything more than a slight throttle increase. My complaint before was that the transmission downshifting was so delayed and sloppy that I downshifted often in a manual mode. Now the transmission downshifts as I think it was designed to do, quickly and without drama. The car seems really frisky and sporty now.
I also tested it with cruise control on a hilly area to see if it might overcorrect because of the increased throttle sensitivity. I saw no faults with cruise control. It is as steady as ever.
I don't think the Sprint Booster is for everyone. I am a geezer and was taught to drive long before cruise control was invented. One thing my instructor(s) taught was "smoothness", and the ability to drive continuously at a stated speed without large corrections and overcorrection. This requires a very light throttle foot, just above resting pressure. Many drivers today cannot do this without cruise control. That's why manufacturers have chosen to dull throttle action. The result is that those with heavy, jerky throttle feet are able to drive more smoothly with no extra effort. So, be prepared to be driving with a very light throttle touch.
One place where one wants a comparatively dull throttle is driving on ice and snow, particularly trying to start on an icy upgrade. Sprint Booster has more or less addressed this issue by coming out with a "3-speed" booster. The first speed is OEM no boost, second is a moderate boost and the third is the full Monty. I know this model is available for BMWs presently, but don't know if it is available for the Genesis.
My research concludes that the Sprint Booster is a simple signal amplifier that multiplies the signal from the accelerator electronics Sprint Booster is made by a small Greek company: www.boulekosdynamic.com. No doubt there is a huge price/profit markup in this device. One commentator estimated manufacturing cost as less than $25. Nevertheless, Sprint Booster uses factory connections, which connectors are often hard to find and buy. Yet, Sprint Booster has done the R&D for which they expect a profit. If you think it is priced too high then don't buy it.
Installation is really easy. You need to unbolt the accelerator pedal. There is a hidden 10mm bolt at the bottom of the pedal which is covered by a plastic tab. Once the bolt is removed slide the pedal downward as the top of the assembly is held to the floor with a simple spade-type connection. Then just remove the factory plug. This is the hardest part as these factory plugs do not release easily. You must squeeze both sides of the plug to release it. Then plug in the Sprint Booster. It is on about a 4" cord. I did not try to tuck into the carpeting this excess cord.
I also tested it with cruise control on a hilly area to see if it might overcorrect because of the increased throttle sensitivity. I saw no faults with cruise control. It is as steady as ever.
I don't think the Sprint Booster is for everyone. I am a geezer and was taught to drive long before cruise control was invented. One thing my instructor(s) taught was "smoothness", and the ability to drive continuously at a stated speed without large corrections and overcorrection. This requires a very light throttle foot, just above resting pressure. Many drivers today cannot do this without cruise control. That's why manufacturers have chosen to dull throttle action. The result is that those with heavy, jerky throttle feet are able to drive more smoothly with no extra effort. So, be prepared to be driving with a very light throttle touch.
One place where one wants a comparatively dull throttle is driving on ice and snow, particularly trying to start on an icy upgrade. Sprint Booster has more or less addressed this issue by coming out with a "3-speed" booster. The first speed is OEM no boost, second is a moderate boost and the third is the full Monty. I know this model is available for BMWs presently, but don't know if it is available for the Genesis.
My research concludes that the Sprint Booster is a simple signal amplifier that multiplies the signal from the accelerator electronics Sprint Booster is made by a small Greek company: www.boulekosdynamic.com. No doubt there is a huge price/profit markup in this device. One commentator estimated manufacturing cost as less than $25. Nevertheless, Sprint Booster uses factory connections, which connectors are often hard to find and buy. Yet, Sprint Booster has done the R&D for which they expect a profit. If you think it is priced too high then don't buy it.
Installation is really easy. You need to unbolt the accelerator pedal. There is a hidden 10mm bolt at the bottom of the pedal which is covered by a plastic tab. Once the bolt is removed slide the pedal downward as the top of the assembly is held to the floor with a simple spade-type connection. Then just remove the factory plug. This is the hardest part as these factory plugs do not release easily. You must squeeze both sides of the plug to release it. Then plug in the Sprint Booster. It is on about a 4" cord. I did not try to tuck into the carpeting this excess cord.