Radio and cluster display stay on after shutting off vehicle

[AMauto]

No DTC's.

On a scantool I can see the signal feed. Shows the door opening and closing which tell me the door switch is working properly, any one experienced this issue? All modules appear to be in healthy condition, confirmed by doing a resistance and voltage test on the CAN bus system.

relays appear to be in good working order. What i do see as an abnormality (don't know if its normal)
IGN1 shuts off when I cycle the ignition off, IGN2 stays on.

I've removed IGN2 relay and I'm still getting signal there.

 

[PMCErnie]

Doesn’t it shut off when you open the driver’s door, OR after 5 minutes?

 

[AMauto]

Doesn’t it shut off when you open the driver’s door, OR after 5 minutes?

No it doesn't

 

[Gunkk]

I would check the status of the IGN1 and IGN2 pins on the PDM vs. voltage at the relays. You may have to de-pin the IGN2 wire for this trick to work, because the PDM may not function with connector A removed. For example, if IGN2 is low and the relay is high, then there's a short to power in the harness or fuse block. If IGN2 is high on the PDM when it shouldn't be, then I'd suspect the PDM.


PDM is underneath the driver crash panel & metal cover.

 

[AMauto]

Below I'll drop pictures of the modules and junction boxes, that particular one you sent I don't see on this car, I've tried to replace the IPDM (first two pictures) once already, didn't work, REinstalled the original one cause the replacement one didnt read the key.

 

[Gunkk]

IPM and PDM are two different modules. Appears that you replaced the IPM, which indeed would cause the key fobs not to work unless reprogrammed properly.



should look like this:


more pics here:

2009-2014 HYUNDAI GENESIS POWER DISTRIBUTION MODULE 95460-3M200 OEM 2010 2011 | eBay

Find many great new & used options and get the best deals for 2009-2014 HYUNDAI GENESIS POWER DISTRIBUTION MODULE 95460-3M200 OEM 2010 2011 at the best online prices at eBay! Free shipping for many products!

www.ebay.com