Bolt size for plastic air shield under engine?

[jasno999]

So I did my first oil change last week and had to remove the plactic air shield under the front of the car. When I did this I noticed one of the bolts was missing.

Can anybody tell me exactly what size bolt this is - I would like to get a replacment.

I think the bolt heads where marked with the #4.

 

[kn5owa]

They are 10 mm "cap screws"

Hyundai uses them everywhere

I bought some at the dealer for spares



**** 10 mm "head"

 

[homeofstone]

I bought extras from dealer too. Also bought some for my Mercedes at Merc dealer. They are not expensive so I bought a bag of them.

 

[jasno999]

Can I get these anywhere else? Are there other places?

 

[kn5owa]

Can I get these anywhere else? Are there other places?

You are in luck - Google part no. 11254-06207-B -- lots of hits - Hyundai's are held together by these things.

The plastic push pins can be gotten on Ebay -- listing No. 371222529360 -- I wouldn't even think about re-using them - in a word - they are lousy fasteners.

 

[xsolara]

You are in luck - Google part no. 11254-06207-B -- lots of hits - Hyundai's are held together by these things.

The plastic push pins can be gotten on Ebay -- listing No. 371222529360 -- I wouldn't even think about re-using them - in a word - they are lousy fasteners.

A few post above said it was 10mm.... the one you show is 12mm
I looked up the part on hyundai parts site and it gives part # 86590-2800 and it's 8mm ???????
Specifications
Hyundai Kia Genuine OEM Push Clips Bumper Cover Mounting Retainer Fastener #86590-28000
OEM Name : RETAINER ASSY - BUMPER COVER MTG
Hyundai MOBIS
Size:
1.Clip Hole (Stem) DIA. : 5/16' (8mm)
2.Clip Head O/D. : 18mm
3.Clip Head I/D. : 6mm
4.Clip Length (Stem) : 12mm
5.Clip Total Length : 15mm
6.Screw Head DIA: 11m
7.Screw Total Length : 18mm
1. This "Retainer ASSY - Bumper Cover MTG" (#86590-28000) is a Genuine Hyundai/KIA Part.
2. This item is used to "Bumper Cover", "Radiator Support Access Cover", "Mud Flaps Splash Guard" and "Fender Liner Cover", etc.

 

[kn5owa]

A few post above said it was 10mm.... the one you show is 12mm
I looked up the part on hyundai parts site and it gives part # 86590-2800 and it's 8mm ???????

The "head" of the cap screw is 10 mm. I just checked one with a 10 mm metric nut driver. I have a package of the referenced 10 mm cap screws in front of me and the part no. for a package of six is 11254-06207-B, as stated, but may be an old no.

These little machine screws are very generic, however - used everywhere on Hyundai's ---- so just do a search for "10 mm cap screws" on Ebay and you can get a whole bag for $5.