Gebop
Registered Member
- Joined
- Nov 20, 2018
- Messages
- 73
- Reaction score
- 38
- Points
- 18
- Genesis Model Type
- 2G Genesis Sedan (2015-2016)
I searched past threads on this subject and replied to one from December. I didn’t realize until afterward but thread I posted in was from the Off Topic forum and I have yet to get a response from my post after the Super Bowl.
Below is my copy and paste from previous post. Any help with this would be greatly appreciated. Previous thread link: G80 BSD problem!
I had someone back in to me last week in the parking lot. It was a low speed tap and the guy that hit me offered to pay out of pocket so I went to a paint shop I’ve used previously. I picked up the car Friday and the $350 cosmetic touchup turned out horrible. Very upsetting and now I don’t want the painter touching the car again.
The BSD was working fine when I drove to Super Bowl gathering yesterday but on the way home I got a Check BSD Warning. I thought there may have been sanding dust on the sensor located on the back bumper, so I cleaned, reset ignition, but the warning remains. Is a reset/recalibration possible or is the warning always indicate a replacement part is required?
Does the BSD use the bumper sensor or are those strictly for backup guidance? This “plate” mentioned by OP, is it something not visible and behind rear bumper skin? Is there a way to reset the system or am I likewise looking at $1,500 repair bill? Not sure if I have screwed myself out of filing an issurance claim at this point and I’m just going to have to pay out of pocket for repaint and BSD repair? Between my insurance deductible and the depreciation hit from a CarFax accident scarlet letter, I’m wondering if the system could be a CPO warranty claim item instead, provided a second fender tap touch up puts the bumper back to like new again?
Any insight or comments appreciated here. The rear cross traffic setting in User Setting > Driving Assist is now grayed out. Coincidentally, I noticed the SCC setting seems to have disappeared. Anyone know if this is somehow related to the BSD setting being grayed out?


Below is my copy and paste from previous post. Any help with this would be greatly appreciated. Previous thread link: G80 BSD problem!
I had someone back in to me last week in the parking lot. It was a low speed tap and the guy that hit me offered to pay out of pocket so I went to a paint shop I’ve used previously. I picked up the car Friday and the $350 cosmetic touchup turned out horrible. Very upsetting and now I don’t want the painter touching the car again.
The BSD was working fine when I drove to Super Bowl gathering yesterday but on the way home I got a Check BSD Warning. I thought there may have been sanding dust on the sensor located on the back bumper, so I cleaned, reset ignition, but the warning remains. Is a reset/recalibration possible or is the warning always indicate a replacement part is required?
Does the BSD use the bumper sensor or are those strictly for backup guidance? This “plate” mentioned by OP, is it something not visible and behind rear bumper skin? Is there a way to reset the system or am I likewise looking at $1,500 repair bill? Not sure if I have screwed myself out of filing an issurance claim at this point and I’m just going to have to pay out of pocket for repaint and BSD repair? Between my insurance deductible and the depreciation hit from a CarFax accident scarlet letter, I’m wondering if the system could be a CPO warranty claim item instead, provided a second fender tap touch up puts the bumper back to like new again?
Any insight or comments appreciated here. The rear cross traffic setting in User Setting > Driving Assist is now grayed out. Coincidentally, I noticed the SCC setting seems to have disappeared. Anyone know if this is somehow related to the BSD setting being grayed out?

