Official 0-60 & 1/4 mile thread

[DKnMP]

Good times for stock for sure. You got the elevation on your side once you start getting mods and a tune!!!!

edit- I need to come down to where you are running tho for that da. Any speedways near you?

Pretty sure the closest is only 1/8th mile and that on a normal day is at least 1.5 hrs drive away from me.

 

[Vortex951]

Pretty sure the closest is only 1/8th mile and that on a normal day is at least 1.5 hrs drive away from me.

are you in southern cali?

 

[DKnMP]

are you in southern cali?

Yup, SOCAL - Southbay area.

 

[Vortex951]

how far are you front fontana raceway? i might try to make a trip down there in the fall for some good DA to run in

 

[Toddasaurus]

Stuck at home from work for quarantine. Decided to take her out for a spin early this morning and not upset by the results at all!

AEM Intakes on the way and boostane to up it to ~ 95

12.88 for the quarter - stock RWD Sport package, CA 91View attachment 27732View attachment 27733

Outstanding! Is this using launch control? Or are you just flooring it from a standstill? Auto shifts?

 

[DKnMP]

how far are you front fontana raceway? i might try to make a trip down there in the fall for some good DA to run in

Damn! For some reason I always thought Fontana was only 1/8th mile, a bit of google says I'm very wrong. So about 50 mins with no traffic, and 1.5hrs with,

 

[DKnMP]

Outstanding! Is this using launch control? Or are you just flooring it from a standstill?

No LC, Custom setting - everything on sport and suspension set at comfort. 91 fuel and a smidge under 1/2 a tank. It was kinda dry and chilly this morning.

Going out again a bit earlier tomorrow morning.

 

[Toddasaurus]

No LC, Custom setting - everything on sport and suspension set at comfort. 91 fuel and a smidge under 1/2 a tank. It was kinda dry and chilly this morning.

Going out again a bit earlier tomorrow morning.

Nice. You can get a better time than that. Use launch control and see how it goes. Then after that, try it a few more times but try to manually shift - shift a bit early from 1st to 2nd, and a little less early from 2nd to 3rd.

I bet you could shave off another tenth or two.

 

[Vortex951]

Damn! For some reason I always thought Fontana was only 1/8th mile, a bit of google says I'm very wrong. So about 50 mins with no traffic, and 1.5hrs with,

It may be I’m not 100 percent sure. I’ll double check on that

 

[Vortex951]

Nice. You can get a better time than that. Use launch control and see how it goes. Then after that, try it a few more times but try to manually shift - shift a bit early from 1st to 2nd, and a little less early from 2nd to 3rd.

I bet you could shave off another tenth or two.

I’m all about leaving the car in auto now

______________________________

Help support this site so it can continue supporting you!

 

[DKnMP]

Nice. You can get a better time than that. Use launch control and see how it goes. Then after that, try it a few more times but try to manually shift - shift a bit early from 1st to 2nd, and a little less early from 2nd to 3rd.

I bet you could shave off another tenth or two.

I've tried LC a few times but seem to get better times without. Too much wheel spin when it comes on boost with LC.

I've been reading some of y'alls posts with regards to manual shifting. Thinking about 5.5k rpm 1st to 2nd and then 5.7k rpm after?

 

[Toddasaurus]

I've tried LC a few times but seem to get better times without. Too much wheel spin when it comes on boost with LC.

I've been reading some of y'alls posts with regards to manual shifting. Thinking about 5.5k rpm 1st to 2nd and then 5.7k rpm after?

Oh dang, sorry - I didn't realize you were RWD. As for manually shifting, I think that's a good start. On my car it seems best if I click to 2nd at about 5.25k, then 2nd to 3rd at 5.75k like you're saying. It may be different on yours!

For whatever reason, mine seems to shift faster when I manually shift. Ever since I installed my JB4 I've had somewhat inconsistent shift times.

 

[Vortex951]

Damn! For some reason I always thought Fontana was only 1/8th mile, a bit of google says I'm very wrong. So about 50 mins with no traffic, and 1.5hrs with,

It does look like Fontana is in fact a 1/4 mile. I’m gonna try to find a test n tune day on a Saturday and maybe get @MG8 to go with for a day trip

 

[Slip_Angle]

Oh dang, sorry - I didn't realize you were RWD. As for manually shifting, I think that's a good start. On my car it seems best if I click to 2nd at about 5.25k, then 2nd to 3rd at 5.75k like you're saying. It may be different on yours!

For whatever reason, mine seems to shift faster when I manually shift. Ever since I installed my JB4 I've had somewhat inconsistent shift times.

@Toddasaurus Curious, do you click the shifter when you see 5.25k or before so it actually shifts at 5.25k?

 

[Toddasaurus]

@Toddasaurus Curious, do you click the shifter when you see 5.25k or before so it actually shifts at 5.25k?

That's when I actually click it. So it completed the shift a little later than that.

 

[mrcleeaan]

Did some runs today, full auto, using LC. Made sure gps turned on to capture the other data for you guys. Ran a little bit slower but not by much. Also, I previously said I was on 91 octane but it's 93, my apologies.

 

[Vortex951]

Did some runs today, full auto, using LC. Made sure gps turned on to capture the other data for you guys. Ran a little but slower but not by much. Also, I previously said I was on 91 octane but it's 93, my apologies.

Nice!! Just keep working on it a little at a time and you will learn exactly what your specific car likes the most. It makes me want to re think my letting the car shift auto mentality though haha

 

[Vortex951]

If it makes you feel better this was my 0-60 with full bolt ons and stock tune using launch control

 

[trdehmer]

I picked up a Dragy the other week so I could tune my clutching on my snowmobile. Now that the snow is gone, I tried it on the G70 3.3T. This is stock on 91oct (18" winter wheels/tires), Sport mode. No LC, automatic mode. Next will be after I put my intakes back in (was in for an oil change the other week), JB4 on Map 1, then Map 2.

Three runs....different days, temps, slope.

I'm surprised a bit how inconsistent it is. I don't like how we have to screen shot the darn results to view them, and when saving runs and labeling them, I've yet to be able to read the entire description I've saved. Is there a different way to view the ENTIRE description I've typed and saved?

 

[Vortex951]

There is a storage of all your runs where you can go back to reference them